Remote configuration is a network management tool that allows you to configure modems anywhere on the Public Switched Telephone Network from one location. With password-protected remote configuration, you can issue AT commands to a remote VT-MODEM-5 for maintenance or troubleshooting as if you were on-site.
Basic Procedure
The following steps are valid regardless of whether the connection is established by the local or the remote VT-MODEM-5.
Establish a phone connection with the remote VT-MODEM-5.
Send three remote configuration escape characters followed by AT and the setup password, and press Enter. Example: %%%ATMTSMODEM. You have four tries to enter the correct password before being disconnected. If the password is correct, the remote modem responds with OK.
You can now send AT commands to configure the remote modem.
When you have finished configuring the remote modem, save the new configuration by typing AT&W0 and pressing Enter.
Type ATO and press Enter to exit remote configuration. You can now break the connection in the normal way.
|
See Also: |
|
|
|